Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle.
MATTHEW S. gave our service a 5 star review on 5/13/2023
Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle.
RITA O. gave our service a 5 star review on 4/16/2023
Found code P2440 for secondary air injection switching valve stuck open bank 1. Customer said he had switching valve and air pump replaced at another shop over a year ago. Found secondary air injection pump to be bad caused switching valve to be stuck. Parts that were installed were aftermarket, customer has been advised to replace left side air injection pump and air injection check valve with toyota parts per TSB 0160-11. Clear check engine light after installation, air injection monitor has run and completed at this time.
AIR INJECTION REACTOR PUMP AND AIR INJECTION CHECK VALVE- Remove & Replace – V8 Bank 1 Left Side
ERIC H. gave our service a 5 star review on 3/11/2023
1. Found code P0571 for brake light switch circuit. Found brake light switch to intermittently be going bad in the vehicle. Recommend remove and replace brake light switch. 2. Set all tires to 32 psi, test sensors, all sensors ok, reset tpms light, light is off at this time. 3. Found drain clogged underneath wiper cowling for water, recommend remove wiper cowling to clear drain. 4. Found combination meter to be bad causing fuel gauge not to work. Combination meter is behind instrument cluster. Recommend remove combination meter to send out for repair. After replacing combination meter, fuel gauge shows correct reading but blinks with odometer mileage symbol. Found fuel tank to be bad which contains built in sending unit. 5. When checking vehicle found vehicle 12 volt battery to be 6 years old. Battery testing 150 out of 325 cold cranking amps. Recommend remove and replace 12 volt battery.
STOP LIGHT SWITCH – Remove & Replace
Remove wiper cowling and wiper arm assembly to clean drains for water
Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle.
MARCO J. gave our service a 5 star review on 12/21/2022
Remove and reinstall four wheels and rear brake drums to inspect brake condition. Inspect entire system for leaks. Lining remaining is: Front ( 30 %) Rear ( 0 %)
Replace rear brake pad linings. Clean and lubricate brake calipers and slide mechanisms. Check and fill brake fluid. Road test vehicle.
Replace front brake pad linings. Clean and lubricate brake calipers and slide mechanisms. Check and fill brake fluid. . Road test vehicle.
Turn front rotors
BRIAN M. gave our service a 5 star review on 12/17/2022