Remove and reinstall four wheels and rear brake drums to inspect brake condition. Inspect entire system for leaks. Lining remaining is: Front ( 60 %) Rear ( 50 %)
ALEXSANDR K. gave our service a 5 star review on 11/12/2022
Found all four engine mounts to be worn causing rough idle when in drive. Recommend remove and replace 3 engine mounts and one transmission mount, road test the vehicle.
ENGINE OR TRANSMISSION MOUNT – Remove & Replace – All
CARL L. gave our service a 5 star review on 10/28/2022
Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle.
Battery is good 97% charge at this time, alternator is charging 14.3 volts, starter does drag once a while, recommend replacing starter assembly.
Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle.
AXLE SHAFT ASSEMBLY – Remove & Replace – Left Side Front
CARL L. gave our service a 5 star review on 9/27/2022
Remove and re install four wheels and rear brake drums to inspect brake condition. Inspect entire system for leaks. Lining remaining is: Front ( 0%) Rear ( 50%) Vehicle needs front brake job including disc rotors.
Replace front brake pad linings. Clean and lubricate brake calipers and slide mechanisms. Check and fill brake fluid. . Road test vehicle.
CAROL W. gave our service a 5 star review on 8/22/2022
Found code P2647 for variable cylinder management stuck on, code P0137 for oxygen sensor bank 1 sensor 2 low voltage, code P0300 for random misfire, code P0301 for cylinder 1 misfire, P0302 for cylinder 2 misfire, code P0303 for cylinder 3 misfire, code P0304 for cylinder 4 misfire, code P0305 for cylinder 5 misfire, and code P0306 for cylinder 6 misfire. Remove oil sending unit to check oil pressure, oil pressure is 25 psi at hot idle and 60 psi at 2500 rpm. Found camshaft adjuster solenoid (variable valve timing solenoid) to be bad. Recommend remove and replace solenoid, change engine oil, clear check engine light and road test.
Haz disposal fee
Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle.